Woodzig Model 40268 Manual [ Confirmed • 2026 ]

Turn the tensioning screw clockwise to tighten, or counter-clockwise to loosen. Once set, tighten the side cover lock nut securely with your wrench. 4. Operating Instructions

Hold the tool firmly with both hands (one hand on the trigger handle, the other on the secondary support grip). Press and hold the safety lock-out switch.

Before operating or servicing your tool, familiarize yourself with its core mechanical limits: 12-Volt Lithium-Ion rechargeable battery Bar Length: 4 inches (10.2 cm) Chain Pitch: 1/4 inch Weight: Approx. 2.5 lbs (with battery installed)

| | OEM Part Number | Compatible Aftermarket | |----------|---------------------|-----------------------------| | Carbide blades (set of 2) | WZ-40268-BL | Freud, Infinity (12" planer blades) | | Drive belt | WZ-40268-BELT | A27 (4L270) V-belt | | Cutterhead bearings | WZ-40268-BRG | 6202-2RS (any brand) | | Dust port adapter | WZ-40268-DUST | Shop Fox D3380 | | Push block set | WZ-40268-PB | Powermatic PM-2000 push blocks | woodzig model 40268 manual

Insert the rear handle/battery assembly into the cutting head assembly.

Do not expose the battery pack to rain or wet conditions. Only use the charger provided by the manufacturer.

Always wear ANSI Z87.1 approved safety glasses, heavy-duty work gloves, and closed-toe shoes. Turn the tensioning screw clockwise to tighten, or

: Always unplug the extension cord from the 110V power source before checking the chain, adjusting tension, or clearing debris.

Before plugging your WoodZig tool into a power source, read and understand these primary operator guidelines to minimize the risk of shock or severe lacerations.

Store the tool horizontally in a dry, locked location out of reach of children. ❓ Troubleshooting Common Issues Probable Cause Recommended Solution No power supply Check extension cord connections and GFCI outlet breaker. Chain cuts slowly or smokes Dull chain or empty oil reservoir Sharpen/replace the chain and refill the bar oil. Chain jumps off the bar Loose chain tension Stop the tool immediately and retension the chain. Motor bogs down under load Forcing the cut too hard Operating Instructions Hold the tool firmly with both

Wear heavy-duty, non-slip work gloves to improve your grip and protect your hands from the sharp chain.

Disclaimer: The Woodzig brand and Model 40268 are discontinued. This guide is based on owner reports, publicly available specifications of similar tools, and general small‑engine/power‑tool best practices. Always exercise caution when using any power equipment.

A: No. The Woodzig brand and specific models like the 40268 have been discontinued for many years. Only second‑hand units remain.

If your manual is lost, you still need replacement parts. Here are the common part numbers for the Woodzig 40268:

Slide a fully charged battery pack into the base of the handle until it clicks into place.